Rafiqul Islam Posted May 25, 2015 Share Posted May 25, 2015 An optical fiber is known as a flexible, transparent fiber made by design glass (silica) or plastic to somewhat of a diameter slightly thicker than that to a human hair. Optical fibers are used most often as a way to transmit light between each of the ends of the fiber and locate wide usage in fiber-optic phone calls, where they permit transmission throughout longer distances and at substantial bandwidths (data rates) than cable cables. Fibers are used as a substitute for metal wires because signals travelling along them with lesser numbers of loss, in addition fibers also are immune to electromagnetic interference, a predicament which metal wires suffer as a result of excessively. Fibers are also utilized for illumination, and are wrapped in bundles so that they is proven to carry images, thus allowing visiting in confined spaces, as in that instance a fiberscope. Specially designed fibers are also used for an assortment of other applications, some of them all being fiber optic sensors and even fiber lasers.Optical fibers typically include a transparent core surrounded by a transparent cladding material along with a lower index of refraction. Light is kept with the core by the phenomenon of total internal reflection that can causes the fiber to act to provide a waveguide. Fibers that support a number of propagation paths or transverse modes are called multi-mode fibers (MMF), while individuals who support a single mode can be called single-mode fibers (SMF). Multi-mode fibers generally have a very good wider core diameter and being used for short-distance communication links and even for applications where high power will have to be transmitted.Single-mode fibers being used for most communication links a bit longer than 1, 000 meters (3, 299 ft).An important aspect of an important fiber optic communication is that of extension belonging to the fiber optic cables such that the losses caused by joining two different cables is kept to somewhat of a minimum. Joining lengths of optical fiber often proves to remain more complex than joining electrical power wire or cable and involves the carefully cleaving belonging to the fibers, perfect alignment of the fiber cores additionally, the splicing of these aligned fibre cores. For applications that demand an important permanent connection a mechanical splice which holds the ends belonging to the fibers together mechanically could be used or a fusion splice which will uses heat to fuse the ends belonging to the fibers together could be implemented. Temporary or semi-permanent connections are made by specialized optical fiber connectors. Link to comment Share on other sites More sharing options...
swansont Posted May 25, 2015 Share Posted May 25, 2015 Is there a question here, or an issue for discussion? Link to comment Share on other sites More sharing options...
imatfaal Posted May 25, 2015 Share Posted May 25, 2015 ! Moderator Note The OP's text is taken from here http://en.wikipedia.org/wiki/Optical_fiber As such it would be better if the text was in quotations and a reference had been given. There is no question obvious and the text was not original - I see no reason to leave the thread open. Locked 1 Link to comment Share on other sites More sharing options...
Recommended Posts