Guest Grenouille3 Posted April 4, 2005 Share Posted April 4, 2005 I'm building an amplifying circuit on PCB using two 741 op-amps, both inverting, giving an overall gain of 10. My output signal though has spikes...I've tried decoupling the power supply and that doesn't make any improvement, is there anyway to get rid of the spike and get a steady output from the op-amp circuit? Link to comment Share on other sites More sharing options...
YT2095 Posted April 4, 2005 Share Posted April 4, 2005 have you tried local de-coupling capacitors across the power to each? 0.1mfd (marked as 104 on ceramic caps) as close to the IC as possible should do the trick, although you don`t state the application or the frequency range used? this will work for MOST applications edit: and why use 2 of them if you only want a gain of 10? Link to comment Share on other sites More sharing options...
Douglas Posted April 5, 2005 Share Posted April 5, 2005 I'm building an amplifying circuit on PCB using two 741 op-amps, both inverting, giving an overall gain of 10. My output signal though has spikes...I've tried decoupling the power supply and that doesn't make any improvement, is there anyway to get rid of the spike and get a steady output from the op-amp circuit?What are you using for a power supply? It's sounds like a chopper. Are you decoupling right on the 741 supply pin(s) with a .01 mf capacitor and with the capacitor leads no longer than 1/4 inch? Do you have plenty of ground plane on the PCB? Keep your leads short from supply to PCB and bypass your supply with a 10 mf cap right at the terminals. Link to comment Share on other sites More sharing options...
RICHARDBATTY Posted April 5, 2005 Share Posted April 5, 2005 Have you used any feed back? Link to comment Share on other sites More sharing options...
Guest Grenouille3 Posted April 5, 2005 Share Posted April 5, 2005 At the moment, i'm decoupling at the power supplies. it's +/- 15 Volts into the 741. Do you think feedback is a feasible option? Would it make the op-amp characteristics more ideal and stabilise the output? Link to comment Share on other sites More sharing options...
RICHARDBATTY Posted April 5, 2005 Share Posted April 5, 2005 feed back - helps to center these sorts of circuits. Link to comment Share on other sites More sharing options...
Douglas Posted April 6, 2005 Share Posted April 6, 2005 At the moment, i'm decoupling at the power supplies. it's +/- 15 Volts into the 741. Do you think feedback is a feasible option? Would it make the op-amp characteristics more ideal and stabilise the output?Are you talking about op amp feedback? If so, you can't operate an op amp ( at least the 741) without feedback. Why do you need 2 op amps for a gain of 10? Link to comment Share on other sites More sharing options...
YT2095 Posted April 6, 2005 Share Posted April 6, 2005 you still don`t state what sort of frequency range they`re to used at? have you considered using a RC twin `T` low pass filter, either on the input stage or the output? you could use an RC or LC filter across your power rail too, op amps don`t use that much power so filtering the rail won`t be an issue. (it`s good practice to do this for all amp circuits anyway). do you know anyone with a dual trace scope you could use, you`de find the problem in seconds that way! Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now