gases separation according to density differences(chemical engineering)

[Haya]

Hi,

i am a junior student doing a research to take part in a world competition, a very important chapter of my research paper depends on gases separation to benefit from each one at a time, i searched about gases separation techniques but i found most of them very expensive and complex. Lately, i found out a method depends on an electronic device that separates gases according to their different densities under high temperature amounts to 1200 C in a closed system. Please could any one recommend me a book/reference/research paper/any thing explain me this technique or any thing explains gases separation by density in general because i strongly need it.

Thanks in advance...

Edited October 20, 2016 by Haya

[sethoflagos]

Which gases are you wanting to separate?

 

Are you researching uranium enrichment?

[Haya]

Which gases are you wanting to separate?

 

Are you researching uranium enrichment?

i want to separate gases produced from the combustion of organic matters (co2, h2o, and other minor gases)to benefit from each one at a time.

[sethoflagos]

i want to separate gases produced from the combustion of organic matters (co2, h2o, and other minor gases)to benefit from each one at a time.

 

The most economic methods of achieving this are based on gas scrubbing. (see https://en.wikipedia.org/wiki/Scrubber)

 

But that does not make them necessarily profitable, There are generally cheaper methods of generating these gases.

 

Separation by density difference is a very expensive method, and very limited in its application.

[Haya]

 

The most economic methods of achieving this are based on gas scrubbing. (see https://en.wikipedia.org/wiki/Scrubber)

 

But that does not make them necessarily profitable, There are generally cheaper methods of generating these gases.

 

Separation by density difference is a very expensive method, and very limited in its application.

very expensive!! i know someone who did this with a cost up to only 5 or 6 dollars!! here is the device which this one made :(click on the photo so that you can see it clearly:

http://www8.0zz0.com/2016/10/21/08/241831114.jpg

[sethoflagos]

Good luck with finding a backer.

[John Cuthber]

very expensive!! i know someone who did this with a cost up to only 5 or 6 dollars!! here is the device which this one made :(click on the photo so that you can see it clearly:

http://www8.0zz0.com/2016/10/21/08/241831114.jpg

No, you know someone who says they can do it for a few dollars.

[Haya]

Good luck with finding a backer.

 

 

No, you know someone who says they can do it for a few dollars.

okay .... thank you so much for helping me!